Mixing fuel
Mixing fuel
CAUTION!
Never use any type of gasoline con-
taining more than 10% alcohol by vol-
ume! Some types of gasoline contain
alcohol as an oxygenate. Oxygenated
gasoline may cause increased operat-
ing temperatures. Under certain con-
ditions, alcohol-based gasoline may
also reduce the lubricating qualities of
some 2-cycle mixing oils.
Generic oils and some outboard
oils should never be used in your
Shindaiwa engine.
Filling the fuel tank
WARNING!
Minimize the Risk of Fire
NEVER
engine.
ALWAYS stop the engine and allow
it to cool before refueling.
ALWAYS Wipe all spilled fuel and
move at least 3 meters (10 feet) from
the fueling point and source before
starting.
NEVER
NEVER operate the engine without the
place and in good working condition.
10
All manuals and user guides at all-guides.com
CAUTION!
This engine is designed to operate on
a 50:1 mixture consisting of unleaded
gasoline and ISO-L-EGD or JASO FD
class 2-cycle mixing oil only. Use of
non-approved mixing oils can lead to
excessive carbon deposits.
Use only fresh, clean unleaded gasoline
with a pump octane of 87 or higher.
Mix all fuel with a 2-cycle air-cooled
mixing oil that meets or exceeds ISO-L-
EGD and/or JASO FD classified oils at
50:1 gasoline/oil ratio.
CAUTION!
Mix and pour fuel outdoors where
FUEL IS HIGHLY FLAMMABLE.
ALWAYS store gasoline in a con-
ALWAYS inspect the unit for fuel
leaks before each use. During each
around the fuel cap and/or fuel tank. If
fuel leaks are evident, stop using the
unit immediately. Fuel leaks must be
repaired before using the unit.
ALWAYS move the unit at least 3
meters (10 feet) away from a fuel
mable materials before starting the
engine.
Examples of 50:1 mixing quantities
U.S.
2-cycle
Gasoline
mixing oil
US Gallons
Fl.oz.
1
2.6
2
5.2
5
13
10
25.6
20
51.2
50
128
IMPORTANT!
Mix only enough fuel for your immediate
needs! If fuel must be stored longer than 30
days and
oil with fuel stabilizer is not
used, it should first be treated with a fuel
stabilizer such as STA-BIL™.
Oil is a registered JASO FD classi-
fied oil and also meets or exceeds ISO-L-EGD
performance requirements. Shindaiwa One is
recommended for use in all Shindaiwa low emis-
sions engines. Shindaiwa One also includes a
fuel stabilizer.
1.
Place the unit on a flat, level surface.
2.
Clear any dirt or other debris from
around the fuel filler cap.
CAUTION!
Slowly remove the fuel cap only after
stopping the engine
3.
Remove the fuel cap, and fill the tank
with clean, fresh fuel.
4.
Reinstall the fuel filler cap and tighten
firmly.
-
5.
Wipe away any spilled fuel before start-
ing engine.
METRIC
2-cycle
Gasoline
mixing oil
Liter
cc.
4
80
8
160
20
400
30
600
50
1000
100
2000