FEUERHAND BABY SPECIAL 276 LED Manual De Instrucciones Original página 22

CHARGING LITHIUM-ION RECHARGEABLE
DE
BATTERIES VIA THE USB-C PORT (SEE FIG. 3)
Refer to the illustrations under "Inserting 2
EN
lithium-ion batteries". Use two 18650 lithi-
um-ion batteries (3.7 volts) and insert them
FR
correctly. Observe the ambient temperature
of (20 ±5) °C.
DA
1. Note the ambient temperature of ((20 ±5) °C.
FI
2. Refer to the illustrations under "Insert-
ing lithium-ion batteries". Use two 18650
EL
lithium-ion batteries (3.7 volts) and insert
them correctly.
IT
3. Place the two 18650 lithium-ion batteries
JA
horizontally in the battery compartment.
The positive pole is on the left, recognis-
NL
able by the +, and the negative pole is
placed against the spring.
NO
4. Close the sealing cap of the battery com-
partment.
PL
5. Only connect the USB-C port to a proper-
SV
ly installed power socket whose mains
voltage matches the technical data of the
ES
mains adapter. Do not use a dimmable
socket or an extension cable. Always insert
the plug into the socket first (Fig.3) and
connect the cable to the mains adapter
before plugging it into the socket. Always
unplug the mains adapter from the sock-
et before unplugging the connector plug
from the socket or disconnecting the con-
nection cable from the mains adapter.
Unplug the mains adapter when there is
a fault, during a thunderstorm and before
cleaning. Pull the mains adapter, not the
connection cable.
22
Fig. 3 - Charging lithium-ion rechargeable batteries
via the USB-C port
6. The LED lantern lamp is charging, recog-
nisable by the red light next to the USB-C
port .
\
7. Wait until the LED Lantern is charged. Dur-
ing the charging process, the LED lantern
cannot be used for lighting. Afterwards,
the lamp lights up green.
OPERATION OF THE FEUERHAND LED LANTERN
BABY SPECIAL 276
1. Make sure that the lantern is not connect-
ed to the power supply. It cannot then
be operated. Remove it from the power
source.
2. Before switching on the LED lantern Baby
Special 276, check whether it needs to be
charged first: The 4 lights on the under-
side light up green for 5 seconds when
the lantern is switched on, then they go
out. You can tell the charge status by the
number of lights that are lit: If all 4 light
up, the battery is fully charged.
\
\$\