Frucosol SELF-SERVICE Manual De Usuario página 56

- Put the ball and the hollow item again and insert them at the same time. Remember that the hollow is
upside and the ball is placed under it; the design of the machine will prevent any incorrect assembly in this
sense
- Screw the four black screws (or two in the case of F-Compact) that hold the squeezer mechanism again.
- Put the peel extractor in the left side of the F-Compact or each of the peel extractors in both sides in the other
2 models. VERY IMPORTANT: These pieces have to be placed properly; to do it see the section of '' Part names''
and the indicative sticker about positioning of the peel extractors.
- Make sure that all the components are properly placed. Proceed to close the open protection cover and check
that the cover makes contact with the security micro.
- With the machine closed, place the clean filter and the buckets to pick up the waste in the sides of the machine.
* Before using the machine again, check carefully the perfect working of the safety devices. Check that the
moving pieces are in good conditions for working, that they don't block itselves and that they are not damaged.
All the components should be assembled properly and fulfill the requirements to guarantee the perfect working
of the machine.
* At least two daily cleanings are recommended. Besides that you will clean and empty the filter and the
buckets for waste as many times as necessary. These operations will be always carried out in the off position.
* TO CONNECT THE SELF-SERVICE MACHINE *
To fix the machine to the cabinet, you have to unscrew
the 4 black ''legs'' of the machie and screw it to the
stand ( it is made with 4 holes that coincide with the
screws of the machine). Once you have made these
things, the machine is ready to be used.
The machine has two switch buttons, one for the
automatic feeder system, and the other one for the
machine. To start to work, you have to press both
buttons, but the machine won't work.
OK
frucosol
frucosol
OK
53
EN