WEG CFW700 Serie Manual Del Usuario página 26

Open collector encoder
(b) Encoder with open collector
output
Refer to Figure A.3 on page 208
signals), the S1 DIP-switches (to select the type of signal of the analog inputs and outputs)
and S2 (RS-485 network termination) and slots 3 and 5 for accessories (see
ACCESSORIES on page
Figura 3.5: (a) to (c) XC1 connection terminals
Signal
A
A
B
B
Figura 3.6: Sequence of the encoder signals
to find the control board, the XC1 connector (control
60).
Installation and Connection
Active low digital inputs
(c) Active low digital inputs
Time
Section 7.2
CFW700 | 21