Philips AquaTrio Cordless 7000 Serie Manual Del Usuario página 22

English
22
Error code
Information code
Cause
The temperature is too low.
The temperature is too high.
Cause
The dirty water tank is full.
The AquaSpin nozzle is stuck.
This is a safety cut-off if
something is stuck in the nozzle
(for instance, a power cable or
a toy).
The air inlet openings are
blocked.
Solution
Make sure the temperature in the room
where the appliance is used, stored, or
charged is above 5 °C. If the device is used
and stored at the correct temperature and
still shows the error code, please take it to a
Philips service center or contact the
Consumer Care Center.
Make sure the temperature in the room
where the appliance is used, stored, or
charged is below 35 °C. Do not expose the
device to direct sunlight or high
temperatures (near hot stoves, in
microwave ovens, or on induction cookers).
If the device is used and stored at the
correct temperature and still shows the
error code, please take it to a Philips service
center or contact the Consumer Care
Center.
Solution
Empty the dirty water tank.
Check the brushes, bearings, motor parts,
and caps for hair or other obstacles and
remove them. If there are no obstacles,
switching the appliance off and on might
solve the problem.
Check the air inlet openings for blockages
and remove them. If this does not solve the
problem, check the whole air passage for
blockages and remove them. This refers to
the nozzle, tube, and the wet filter.