VIDEOPORTERO 2 HILOS | 2-WIRE VIDEO DOOR ENTRY SYSTEMS | VIDÉO-PORTIER 2 FILS
Program the monitors / telephones from the main entrance panel of the
5
building.
Programming steps
1. Move the PROG switch to the OFF position; Return the switch to the
ON position.
2. Press the door open button
the monitor and the main entrance panel.
3. Located on the main street panel, make the call to the apartment
where the monitor to be programmed is located. The entrance panel
will emit a confirmation beep, the monitor has been programmed.
1
1
2
Note: Once the monitor is programmed, make sure that the PROG switch is in the ON position.
Note: Maximum time of 1 minute between steps 1,2 and 3. After the maximum time you must
start programming from step 1.
Note: For another type of monitor/telephone, consult the corresponding manual.
Entrance panel configuration adjustments, see page 65.
6
In the case of an exterior entrance panel (Gate) of a Housing compound
7
with 2 or more buildings: Assign the push-buttons of the external pa-
nel to each of the inner buildings. See ASSIGNING PUSH-BUTTONS TO
EACH BUILDINGS (only for external panel), page 62.
58
2
OFF
ON
. The audio will be activated between
3