Cherubini BLUE BUS TDS Serie Instrucciones página 35

To enable (automatically) or disable (manually) the sun sensor, a remote control with Sun/Wind function
must be used. Briefly press the SEL button: the remote control shows the existing status (see symbols).
To change the setting press the SEL button again for about 2 seconds until the motor responds with a
confirmation sequence.
SEL
To activate the TEST function, hold the SET button down for around 2 seconds, until the awning opens
for 10 seconds and closes briefly to confirm that the test has been activated. The Test function lasts for
3 minutes, during which the wind and sunlight threshold settings can be checked, without waiting for
activation times. After 3 minutes, the WindTec sensor returns to normal operational mode. During the
wind-alarm the blue led inside the control unit is on.
WIND FUNCTION TEST (WINDTEC, WINDTEC LUX)
To avoid errors during the wind function test, it is suggested that the sunlight function be deactivated.
By spinning the anemometer fins, when the speed detected by the sensor exceeds the threshold set, the
motor commands the closing of the awnings.
SUN FUNCTION TEST (WINDTEC LUX)
Make sure that the sunlight function is on. When the sensor detects a change in the sunlight intensity,
it opens the awning if the sunlight intensity goes above the threshold set, or it closes the awning if the
light intensity goes below the threshold set. It is possible to repeat this test several times, so as to find
the desired adjustment levels precisely.
ENABLE / DISABLE THE SUN SENSOR
(WINDTEC LUX)
SEL
2 sec
display
SEL
Skipper
Skipper
TEST MODE (
WINDTEC/WINDTEC LUX)
set
2 sec
Wind and sun sensor activated
Only wind sensor activated
35