Cleaning And Maintenance - Zavor LUX Manual Del Usuario

3. Press the START/STOP button. The Multi-cooker will begin cooking after the
delay time has elapsed.
FOR EXAMPLE: It is 11:30 a.m. and you want your dinner to be ready by 6 p.m.
Your recipe calls for 12 minutes of high pressure cooking. You can program your
delay time for 6 hours and then the pressure cooking program for 12 minutes. You
do this by pressing the pressure cook function once and then adjusting the time
with the + or – buttons until it reads 00:12 minutes and then pressing the TIME
DELAY button once and then the + or – buttons until the panel reads 06:00 hours.
Next, you press the START/STOP button, and you're all set! The cooker will start
cooking at 5:30 p.m. and your dinner will be ready at 5:42 p.m. The automatic
warm function will ensure that it doesn't get cold.

Cleaning and Maintenance

Do not wash any parts of the Multi-cooker in the dishwasher except for the
removable cooking pot. Always wash the removable cooking pot thoroughly after
every use, or if it has not been used for an extended period of time.
1. Unplug the Multi-Cooker and let the unit cool before cleaning.
2. Remove the removable cooking pot and wash with warm soapy water or
in the dishwasher. Hand washing is always recommended. Rinse and dry
thoroughly.
3. Wipe the outer housing with a clean damp cloth and rinse the lid with warm
water and soap. Do not submerge the Multi-cooker or the lid in water.
NOTE: To remove an odor from the inside part of the lid, clean it with water
and vinegar (1:1 ratio).
4. Remove the condensation reservoir by pulling it down. Wash with warm,
soapy water. Rinse and dry thoroughly. Replace by pushing it back into place.
5. Carefully remove the y-shaped silicone gasket attachment by grasping the
center of the metal "Y" and pulling. Remove the silicone gasket from the
metal ring. Clean the silicone gasket with warm soapy water. Rinse and
dry thoroughly. Place the gasket back on the metal ring and then place the
Y-shaped attachment back onto the lid by placing the silicone center piece
back on the steel tip and pushing down.
NOTE: The silicone gasket must always be properly positioned on the underside
of the lid; otherwise the unit will not work. Check periodically to make sure that
it is clean, flexible, and not cracked or torn (See "Getting Started" section in this
manual).
6. If the silicone gasket appears damaged, cracked or torn, do not use the unit
and contact ZAVOR Customer Service Department at 1-855-928-6748 or visit
the ZAVOR website to purchase a new silicone gasket at www.zavoramerica.
com.
7. For optimal performance, the bottom of the cooker, in the area under the
removable cooking pot where the temperature sensor and heating pad are
located must be cleaned after each use. Wipe with a soft damp cloth and be
26