Publicidad
Idiomas disponibles
Idiomas disponibles
Replacement parts
Replacement parts are available at your dealer or Service Center.
System outer foil and inner
blades
Replacement parts for
ES‑LT71
System outer foil
Inner blades
Cleaning the self-cleaning recharger
Beard trimmings may become attached to the cleaning tray of the
self‑cleaning recharger. Follow the steps below to remove them.
We recommend doing this each time you change the detergent
cartridge.
1. Be sure to remove the water tank and the
appliance plug from the self‑cleaning
recharger.
•
Be careful not to spill the cleaning liquid.
. Gently wipe off any beard trimmings
attached to the inside of the cleaning tray
with a cloth or tissue paper dampened
with water.
•
Clean the corners and uneven parts of
the cleaning tray with a cotton swab
dampened with water.
All manuals and user guides at all-guides.com
Warning
Do not wash or apply water to the AC adaptor or self-
cleaning recharger. Failure to observe this may cause
WES901
electric shock or result in short circuits.
WES907
•
Do not pull hard on the rubber blade protector at the bottom of
the cleaning tray. The rubber may come off if you pull hard on it.
WES906
It is only necessary to pull it up slightly.
Beard trimmings may clog the drain at the bottom
of the cleaning tray.
In this case, you cannot clean or dry the shaver.
Push the beard trimmings down through the drain
with a tooth pick etc.
1
Removing the built-in rechargeable battery
Remove the built‑in rechargeable battery before disposing of the
2
shaver. Please make sure that the battery is disposed of at an
officially designated location if there is one. Do not dismantle or
replace the battery so that you can use the shaver again. This
could cause fire or an electric shock. Have the battery replaced by
an authorised service centre.
•
Disconnect the power cord from the shaver when removing the
battery.
When the water does not drain from the cleaning tray
11
Publicidad
