Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the shaver
Use the self‑cleaning recharger in temperatures between 15 °C
and 5 °C.
1
1
Insert the appliance plug
into the self-cleaning
recharger.
2
2
Remove the protective
cap and then attach the
shaver.
3
3
Plug in the AC adaptor.
•
Remove any soap or water on the
shaver if it has been washed with
hand soap or any other detergent.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not
deformed or damaged when you
are attaching the shaver.
4
4
Press the SELECT button to select the
course.
•
Each time you press the SELECT button, the course
changes from "Clean/Dry/Charge"
"Charge".
•
The courses start approximately 6 seconds after they
are selected.
•
The course will be aborted if the power is cut off. In this
case, perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank
as the cleaning liquid may spill causing a malfunction.
All manuals and user guides at all-guides.com
2
3
1
"Dry/Charge"
Course
Charge
1 Charge
0 to 60 min
Clean
2 Clean/Dry/
Charge
10 min
•
It is not possible to change the course after the
"Clean/Dry/Charge" course has started.
Dry
3 Dry/Charge
100 min
•
It is possible to change to the "Clean/Dry/Charge"
course even after the "Dry/Charge" course has started.
* When the ambient temperature of the self‑cleaning recharger is
low (approx. 15 °C or lower), the time it takes to dry the shaver
increases.
•
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the CLEAN
and DRY lamps will blink when the "Clean/Dry/Charge" course is
selected, or the DRY lamp will blink when the "Dry/Charge"
course is selected.
Time required (guide)
Dry
Charge
50 min
0 to 60 min
(0 min*)
Charge
0 to 60 min
Publicidad
