Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
If warm, allow the battery to cool be-
fore charging. Charge the battery
(13) when only the red LED on the charge
level indicator (14) is illuminated.
1. If necessary, remove the battery (13)
from the device.
2. Slide the batteries (13) into the char-
ging slot of the Parkside X 20 V Team
charger.
3. Plug the charger (16) into a power out-
let.
4. Once charging is complete, disconnect
the charger from the mains supply.
5. Remove the battery (13) from the char-
ger.
Attaching/replacing
accessories
Switch off the device and
remove the rechargeable
battery before attaching or
replacing accessories in order
to avoid hazards and injury.
Attaching accessories
1. Place the lug (7) of the grass shears
blade (5) or the shrub shears blade (9)
in the groove on the underside of the
device head (4).
2. Fold the accessory in the direction of
the device head (4).
3. Press the two release buttons (6) on the
right and left of the accessory.
4. Let go of the release buttons (6) when
the accessory is fl ush against the de-
vice head (4).
5. Check that the accessory is fi rmly sea-
ted by pulling on the accessory.
30
Removing accessories:
1. Press the release buttons (6) on the
right and left of the accessory.
2. Fold the accessories away to the front.
3. Remove the accessories by lifting them
upwards.
Removing/inserting the
battery
Only insert the rechargeable battery
once the battery-operated tool is rea-
dy for use. Risk of injury!
1. To remove the battery (13) from the de-
vice, press the release button (12) on
the battery and pull the battery out.
2. To insert the battery (13), push the
battery along the guide rail into the
device. You will hear it click into place.
Switching on and off
1. If necessary, remove the blade guard (
8/10) before switching the device
on.
2. To start the device, push the switch lock
(1) forwards and press the on/off switch
(2). Then release the switch lock (1).
The equipment runs at top speed.
3. In order to switch off, let go of the on/
off switch (2).
After switching the unit off,
the blades take a short time
to stop moving. Let the blades
come to a complete standstill.
Do not touch the blades or
slow them down before the
moving parts have come to a
standstill.
Publicidad
