HQ-Power VDPLW108 Manual Del Usuario página 3

• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
6. Use
a. 6 DMX Channels
CHANNEL 1: master DIMMER, effect channels 2, 3, 4 and 5.
CHANNEL 2: red. If no macro, it is modified by channels 1 and 6.
CHANNEL 3: green. If no macro, it is modified by channels 1 and 6.
CHANNEL 4: blue. If no macro, it is modified by channels 1 and 6.
CHANNEL 5: macro. This channel overrides channels 2, 3 and 4 but will still be modified by channels 1
and 6.
CHANNEL 6: strobe function.
b. Detailed DMX Values Per Channel
Channel
1
2
3
4
5
6
c. DMX512 Connection
Connect an XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDPLW108. Multiple VDPLW108s can be linked through serial linking. The linking
cable should be a two-core screened cable with XLR input and output connectors.
d. DMX512 Chain with Termination
05.01.2010
Description
DIMMER
RED
GREEN
BLUE
MACROS
STROBE
VDPLW108
From To Function
0 255 From 0 to 100% brightness
0 255 From 0 to 100%, if no macro is on
0 255 From 0 to 100%, if no macro is on
0 255 From 0 to 100%, if no macro is on
0 4 No function
5 84 16 colours fixed
85 169 Colour changes with adjustable speed
170 255 Colour fade in and out
0 255 For slow to fast
3
©Velleman nv