Satelec Mini L.E.D Manual De Instrucciones página 8

8 – TROUBLESHOOTING
If a problem appears, before calling your
dealer's after sales service:
1) Check that the base
correctly connected to the mains to
ensure that the battery recharges
normally. If the LED is not lit up in
spite of correct connection, contact
the after sales service.
2) Check that the battery indicator shows
that it is fully charged before pressing
the trigger. If the LED is red, an
automatic safety mechanism will stop
the unit from being activated. In this
case, recharge your
replacing the handpiece on the base
station, or just replace with a second
fully charged battery.
3) Intensive use of the unit may possibly
cause a rise in temperature inside the
unit. In this occurs, an automatic
safety mechanism will stop the Mini
L.E.D., and the status indicator will
flash red. Leave the unit for a few
minutes to cool down and then carry
on as normal.
9 – TECHNICAL SERVICE
Your dealer's after sales service is at your
disposal for help with any technical
problem.
10 – SPECIFICATIONS
Unit
Model:
station is Weight:
Size:
Classification:
Power supply adapter
Input voltage:
Frequency:
Output voltage: 12V
battery by Output current: 1.25A
Classification:
Base station
Input voltage:
Protection:
Classification:
Battery
Type:
Size:
Capacity:
Optical specifications
Wavelength:
Intensity
(Ø7.5mm):
Power:
Homologation
CE
IEC 60 601-1
60 601-1-2
8
Mini L.E.D.
190g
Ø23 x 200mm
Ordinary
Type B
Continuous service
IPX0
110 - 240V AC
47 - 63 Hz
II
IP 40
12VDC
Fuse 2A
Continuous service
IPX 0
Lithium-Ion
90 x Ø21mm
2000mAh
420-480nm
1100 mW/cm²
450-500 mW