Descargar Imprimir esta página

De Dietrich LK6GVX1A Guía De Utilización página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
3
USE
burner(s) which have been switched off for
less than 30 seconds.
3.10 BOIL FUNCTION
With this function you can boil and simmer
water to cook pasta, for example.
Select a zone and give a short press on the
«Boil» key
..
The default quantity of water displayed is 2
litres, but you can change it using the + or -.
Set the quantity of water required (from 0.5
to 6 litres).
Confirm by pressing the «Boil» symbol
or wait a few seconds for automatic
confirmation.
Cooking starts.
A beep sounds when the water is boiling and
the «Boil» symbol scrolls through the display.
You can then add the pasta and confirm by
pressing the «Boil» key.
By default, the display shows the power and
a cooking time of 8 minutes.
You can still adjust the power and the
cooking time suggested.
A beep sounds out when cooking is finished.
NOTE: It is important that water is at ambient
temperature at the start of cooking or the
final result will be distorted.
Do not use a cast iron pan with this function.
You can also use this function to cook any
food that needs to be cooked in boiling water.
Advice on how to save energy
Cooking with the correctly sized lid saves
energy. If you use a glass lid, you can control
your cooking perfectly.
3.11 SAFETY PRECAUTIONS AND
RECOMMENDATIONS
Residual heat
After intensive use, the cooking area you
have just used will remain hot for several
minutes.
An «H» is displayed during this time.
.
So, avoid touching the zones concerned.
Temperature limiter
Each cooking area is fitted with a safety
Spillage protection
The hob may be switched off in the following
- A spillage in the touchkey area.
- Damp cloth placed over the touchkeys.
- A metal object placed on the touchkeys.
Remove the object or clean and dry the
touchkeys and then continue cooking.
In these cases, the
accompanied by an audible signal.
«Auto-Stop» system
If you forget to switch off a pan, your
hotplate has an "Auto-Stop" safety function
that automatically switches off the forgotten
cooking zone after a preset time (between
16
sensor that continuously monitors the
temperature of the bottom of the pan. In the
event that an empty pan is left on a zone
that is switched on, the sensor automatically
adapts the power delivered by the hob and
limits the risk of damaging the cookware or
the hob.
three cases:
symbol is displayed

Publicidad

loading