Functional Description - Makita 4100NH3 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of cut
013769
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
CAUTION:
After adjusting depth of cut, always tighten the
•
wing bolt securely.
Sighting
001674
Align the edge of the front of the base with your cutting
line on the workpiece.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
013740
1. Wing bolt
2. Base
1
2
1. Switch trigger
2
2. Lock button /
Lock-off button
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger, push in the lock button and then
release the switch trigger. To stop the tool from the
locked position, pull the trigger fully, then release it.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
CAUTION:
Do not pull the switch trigger hard without pressing
•
in the lock-off button. This can cause switch
breakage.
For tool without lock button / lock-off button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Removing or installing diamond wheel
(optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the
diamond wheel.
Use only the Makita wrench to install or remove
•
the diamond wheel.
1
2
013766
To remove the diamond wheel, hold the outer flange
with the wrench and loosen the hex bolt clockwise with
the hex wrench. Then remove the hex bolt, outer flange
and diamond wheel.
6
1. Wrench
2. Hex wrench
3. Outer flange
4. Diamond wheel
3
4