Publicidad
Step 18
Step
1
D132
Groove
å
Insert the DRAWER SIDES (D132 and D138) at an angle
into the slot at each end of the LEFT DRAWER FRONT (K).
3
M65
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M65) to the LEFT
DRAWER FRONT (K). Tighten one HIDDEN CAM.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D138
K
Maximum
210 degrees
Minimum
190 degrees
Hidden part using
recycled material.
Color may vary.
K
VIEW THE T-LOCK BOX VIDEO
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D730) into the grooves
in the DRAWER SIDES (D132 and D138) and LEFT
DRAWER FRONT (K).
4
Arrow
D132
å
Fasten the DRAWER BACK (D68) to the DRAWER
SIDES (D132 and D138) and DRAWER BRACE (M65).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other DRAWERS.
424361
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D730
D132
K
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(30 used in this step)
D68
M65
D138
D138
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 23
Publicidad
