Yakima LANDING PAD 22 Instrucciones De Montaje página 3

3
PREPARE THREADS.
Be sure the threads are clear of paint by
carefully threading your fastener in and
out of the hole a few times while blowing
away any debris that accumulates.
NOTE: If there are multiple holes
in the front pocket, use the
forward-most holes. Use the
rear-most in the rear pockets to
gain maximum crossbar spread.
ATTACH LANDING PADS USING YOUR VEHICLES
5
SPECIFIC HARDWARE (IDENTIFIED ON PAGE 2).
A. Place Landing Pad over each roof pocket making sure arrows face
B. Install the metal washer on each bolt with the concave side facing up.
BE SURE TO USE
C. Using the 5mm hex wrench, guide fastener with washer through
THE CORRECT
PADS AND
D. Jostle and rotate Landing Pad in all directions to ensure it is snug,
HARDWARE TO
AVOID VEHICLE
DAMAGE!
A
INSTRUCTION #1035907D-3/12
have a plug in the threads
which must be removed.
the direction specific to your vehicle.
Landing Pad, and into the threaded mounting point in the roof.
but also allows a small amount of adjustment to prepare for final
alignment and tightening in step 6. Repeat for all Landing Pads.
B
Concave side up.
NOTE: Some vehicles
C
4
INSTALL PADS TO BASES.
Attach each pad to each base.
4X
Warning: do not allow
edges of pad to curl under!
NOTE: Final tightening will
happen in the next step.
4X
D
4X