PRIXTON BARI Manual Del Usuario página 16

Operational use of the panel left to right
Espresso (on/off switch i)
Push the button for espresso preparation Indicator 1 will come on
When the indicator 2 comes on
Push the pump switch to make espresso coffee
Steam switch
Push the switch to make froth from milk Push the On/Off switch I and the steam switch
Indicator 1 will come on
When the indicator 2 comes on
Use the steam controller to release the steam to cup When the required purpose is
reached
Turn the steam controller to off position and press the steam switch to "0" position to stop
generating the steam
Pump switch
Push the switch to make espresso coffee when the indicator 2 comes on
When desired coffee is obtained or the colour of coffee changes weak obviously Push the
switch to the 0 position to stop making coffee
Coffee (on/off switch ii)
This is used to make drip coffee only
When selected the process of making coffee will start. Indicator 3 comes on
It is a assumed that the user has filled the reservoir with water and coffee in the machine
When finished the indicator 3 stays on indicating the plate is warming
When warming not needed the user turns off the switch manually. Indicator 3 is off
Operation manual
Before the first use
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with
warm water as follows:
Open the top cover, and pour 1250ml water into water tank.
Set nylon funnel in the funnel support (add no coffee powder). Place a paper filter in the
funnel, and then replace the top cover.
Set steel mesh into metal funnel (no coffee in steel mesh).
Place carafe on keeping warm plate and put small carafe on removable shelf.
Plug the power cord into the outlet. Press down the ON/OFF switch for drip coffee, the
indicator 3 will be illuminated. The appliance will begin working. You may stop to brew by
pressing the switch to "0" position at any time, the indicator will be extinguished. The
appliance will continue brewing once pressing the switch again.
Press down ON/OFF switch for espresso coffee, the indicator 1 is illuminated. The coffee
maker begins to be pre-heated. When the indicator 2 is illuminated, the pre-heating is
finish, pressing the pump switch to "I" position and water will flow out.
After water not dropping out any more. You can pour the water in each container out
then clean them thoroughly, now you can start brewing.
Note: There may be noise when pump the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
16