PRIXTON BARI Manual Del Usuario página 18

You should turn off the ON/OFF I switch manually when desired coffee is obtained or the
colour of coffee changes weak obviously, the indicator go out and the coffee maker stops
working, your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you
need operate manually sometimes!
After finishing making the coffee, you can take the metal funnel out through turn
clockwise. Then pour the coffee residue out with the steel mesh pressed by press bar.
Let them cool down completely, then rinse under running water.
Frothing milk/ make cappuccino
You get a cup of cappuccino when you top up a cup of espresso with frothing milk. Note:
during making steam, the metal steel must be assembled in position. Method:
Prepare espresso first with container big enough according to the part "MAKE ESPRESSO
COFFEE", make sure that the steam controller is at the off position.
Turn on the ON/OFF switch I and the steam switch, waiting for until the indicator 2 is
illuminated.
Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are
recommended to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm,
and bear in mind that the milk increases in volume by 2 times, make sure the height of
jug is enough.
Turn the steam controller in anti-clockwise slowly, steam will come out from the
adjustable steam outlet.
Note: Never turn the steam controller rapidly, as the steam will accumulate rapidly in short
time which may increase the potential of the risk of explosion. During operation, if the
indicator 2 is extinguished, you must turn the steam controller to off position and press
the steam switch to "0" position again. Waiting for until the indicator 2 is illuminated again
and turn the steam controller in anti-clockwise, the steam will come out again.
Insert the frothing device into the milk about two centimetre, froth milk in the way
moving vessel round from up to down.
When the required purpose is reached, you can turn the steam controller to off position
and press the steam switch to "0" position to stop generating the steam.
Note: Clean frothing device with wet sponge immediately after steam stops generating,
but care not to hurt!
Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten
to taste and if desired, sprinkle the froth with a little cocoa powder.
Close the ON/OFF switch to cut the power source off.
Note: we recommend you allow the maker to cool down at least for 5 min before making
coffee again. Otherwise burnt odor may occurred in your Espresso coffee.
Producing steam to heat liquids
The steam tube (without the frothing device) can be used to make hot beverages like
drinking chocolate, water or tea.
Method:
Open the top cover, add proper drinking water into water tank according to the gauge.
Close the top cover, then connect the appliance to power supply source.
Make sure that the steam controller is at the off position.
Turn on the ON/OFF switch and steam switch, the indicator 1 is illuminated. The coffee
maker begins to be pre-heated.
Waiting for until the indicator 2 is illuminated, it shows that the pre-heating is finished.
Remove the frothing device from the steam tube.
Dip the steam tube into the liquid to be heated. Turn the steam controller in
anti-clockwise slowly to start making steam.
18