Lionelo Bastiaan RWF i-Size Manual De Usuario página 13

included in the set to make installation easier if needed (fig. 5).
4.
Push the baby seat downwards and then push towards the seat in order to press
the anti-rotation frame against the car seat as far as possible (fig. 7). Make sure
the baby seat is pressed firmly against the backrest of the car seat.
5.
Push the base using a left-right movement towards the backrest to make sure it
is pressed as firmly as possible against the car seat.
6.
The green indicator on the ISOFIX button must be visible on both sides (fig. 8).
7.
Attach the Top Tether strap to the anchorage points in the car (fig. 9A, 9B). The
anchorage points can be in different locations, depending on the vehicle.
8.
Tighten the Top Tether strap and make sure the indicator is green (fig. 10). The
seat is now correctly installed in the car (fig. 11).
9.
Unbuckle the seat belts and then put the child in the seat.
10. To fasten the belts in the seat, connect the belt connectors and then insert the
belts into the buckle (fig. 12). You will hear a characteristic click.
11. Pull the strap to tighten the belts (fig. 14). Press the button and pull on the shoulder
belts to loosen the belts (fig. 15).
Note! Make sure that the seat belts fit tightly around the child's body and that they
are not twisted. Make sure the lap belts run low and protect the child's pelvis. The
belts should be tight against the child's body, but should not be too tight and cause
discomfort.
Note! Children less than 75 cm tall may only use the seat with a reduction insert (fig. 16).
12. To release the 5-point seat belts, press the red button on the buckle and loosen
the belts (fig. 13).
SEAT DISMANTLING – ISOFIX
To detach the ISOFIX arms, press the ISOFIX release buttons (16, fig. A) on both sides.
The indicator on the ISOFIX button will turn red. Pull the ISOFIX sliding lever (17, fig.
A) to retract the ISOFIX arms.
SEAT DISMANTLING – TOP TETHER
Loosen the strap. Detach the Top Tether strap from the anchorage points in the car.
The indicator will turn red.
SEAT BELT DISMANTLING
To remove the seat belts, loosen them as much as possible (fig. 15), remove them from
‑ 13 ‑ EN