Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 during product operation. If
operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or perform-
ing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Look for these accessories where you purchased this product:
„ Edge Guide ........................................................................................................................................................201985001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended
can result in serious personal injury.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS
MAINTENANCE
ACCESSORIES
NOTE: ILLUSTRATIONS START ON PAGE 14
Rinse out the upper wheel guard after each use to prevent
the slurry produced during wet cutting from accumulating
and hardening. This material can harden and clog the inside
of the upper wheel guard.
NOTE: Do not use a screwdriver or sharp object to dislodge
hardened material as parts of the watering system could be
damaged. Be careful NOT to allow water to enter the motor
housing through vents during rinsing.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
WHEEL MAINTENANCE
If wheel cutting ability deteriorates or becomes slow, the wheel
may need resurfacing. Cutting a brick paver will resurface
the wheel and improve wheel cutting ability.
12 — English
Publicidad
