Ryobi PBLHTS01 Manual Del Operador página 8

„ Hold water bottle so that nozzle faces down.
NOTE: Water will not escape the bottle unless the tip of
the nozzle is depressed.
„ Insert the water bottle as shown. Gently press down on
the bottle until it clicks into place.
NOTE: Keep the flow adjustment knob in the OFF position
until you are ready to begin wet cutting.
CAUTION:
Water bottle is designed for water only. Use of any other
fluid may cause damage to the tool.
WARNING:
A 5 in. wheel is the maximum wheel capacity of the saw.
Also, never use a wheel that is too thick to allow outer
wheel washer to engage with the flat on the spindle.
Larger wheels will come in contact with the wheel guards,
while thicker wheels will prevent wheel screw from secur-
ing wheel on spindle. Either of these situations could
result in a serious accident.
WARNING:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
WARNING:
Do not use toothed or segmented wheels. Use only
continuous rimmed diamond wheels suited for masonry
materials.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
ASSEMBLY
INSTALLING CUTTING WHEEL
See Figure 2, page 13.
„ Remove the battery pack from the saw.
„ Remove the wheel wrench (5 mm hex key) from the stor-
age area.
„ Depress the spindle lock button and remove the wheel
screw and outer wheel washer.
NOTE: Turn the wheel screw clockwise to remove.
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
NOTE: Do not run the saw with spindle lock engaged.
„ Wipe a drop of oil onto the inner wheel washer and outer
wheel washer where they contact the wheel.
WARNING:
If inner wheel washer has been removed, replace it before
placing cutting wheel on spindle. Failure to do so could
cause an accident since wheel will not tighten properly.
„ Replace the inner wheel washer.
„ Fit the cutting wheel inside the wheel guard and onto
the spindle.
„ Replace the outer wheel washer.
„ Depress the spindle lock button, then replace the wheel
screw. Tighten the wheel screw securely by turning it
counterclockwise.
„ Return the wheel wrench to the storage area.
NOTE: Never use a cutting wheel that is too thick to allow the
outer wheel washer to engage with the flats on the spindle.
OPERATION
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Battery products are always in operating condition. There-
fore, the switch should always be locked when not in use or
carrying at your side.
8 — English