Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - handshower
71744xx1, 32327xx1, 72414xx1, 31404xx1,
31433xx1, 31408xx1, 31527xx1, 32557xx1,
74555xx1
Flow rate - handshower
71748xx1, 32314xx1, 72419xx1, 31444xx1,
31446xx1, 31448xx1, 31733xx1, 32553xx1,
74553xx1
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
Inspect the product for shipping damage
before installation.
damage made after the product is installed
will not be honored.
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The four-hole trim sets require rough 06646000
(not included).
The three-hole trim sets require
rough 06607000 (not included).
• Four-hole models only: Protection against
backflow is provided by a check valve in the
handshower elbow and by an automatically
resetting diverter.
• 1.8 GPM models only:This showerhead is for
use with an automatically compensating valve rated
at 1.3 GPM (4.9 L/min) or less.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.8 GPM (6.8 L/min)
2.0 GPM (7.6 L/min)
Claims for shipping
• 2.0 GPM models only: This handshower is for
use with automatic compensating valves rated at
1.5 GPM (5.7 L/min) or less.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or other
approved anti-scald device.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher than
112°F (44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
