Bosch GPL3T Instrucciones De Funcionamiento Y Seguridad página 5

The optional leveling base makes it easy to level the GPL3T across
its length and its width.
1. Orient the laser tool such that laser end is at the narrow end of
the base.
2. Please the laser tool on the base such that it sits between the
alignment ridges and that its threaded mount sits over the stud at
the center of the base.
3. Level the laser tool lengthwise by rotating the knob nearest to the
laser aperture until the bubble is between the two lines on the
spirit level.
4. Level the laser tool widthwise by rotating the knob that is furthest
away from the laser aperture until the bubble is between the two
lines on the spirit level.
Introduction:
Congratulations! You have just purchased a time-saving precision
laser tool of superior quality. The GPL3T is both precise and easy to
use. Simply turn the laser tool on and you have three, perfectly
square beams for your level, plumb and square applications. Use the
bubble vials to manually level your new GPL3T torpedo laser level.
Turning GPL3T on and off:
To turn laser tool on, turn the knob on the back of
the unit clockwise.
To turn laser tool off, turn the knob counter
clockwise to the original position.
Leveling GPL3T:
The laser tool has three 90˚ beams that can be used to level, plumb
and square.
When the laser tool is in the
horizontal orientation the bubble
in the bubble vial in the middle of
the unit must be centered.
When laser tool is in the vertical
orientation the bubble in the bubble
vial closest to the beams must
be centered.
Leveling Base
Operating Instructions
-5-
On/Off