Scheppach HS100S Traduccion Del Manual De Instrucciones Originale página 30

• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• Legs 4x (16)
• Long crossbar 2x (17)
• Short crossbar 2x (18)
• Support strut long 2x (21a)
• Support strut short 2x (21b)
• Cross member 4x (21c)
• Support frame 2x (16b)
• Bench extension 2x (8)
• Rubber feet 4x (16a)
• Rip fence (15)
• Saw blade guard (4)
• Transverse stop (7)
• Suction hose (5)
• Push stick (9)
• Ring spanner 10/21 mm (22a)
• Ring spanner 10/13 mm (22b)
• Hexagon head bolt 32x (19)
• Hexagon head nut 24x (20)
• Riving knife (6)
4. Intended use
The bench-type circular saw is designed for the slitting
and cross-cutting of all types of timber, commensurate
with the machine's size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed pur-
pose.
Any use other than that mentioned is considered to be
a case of misuse. The user/operator and not the manu-
facturer shall be liable for any damage or injury result-
ing such cases of misuse.
Only suitable saw blades (HM or CV saw blades) may
be used for the machine.
30 | GB
It is prohibited to use any type of cutting-off wheel. To
use the machine properly you must also observe the
safety regulations, the assembly instructions and the
operating instructions to be found in this manual.
All persons who use and service the machine have to
be acquainted with this manual and must be informed
about its potential hazards. It is also imperative to ob-
serve the accident prevention regulations in force in
your area.
The same applies for the general rules of occupational
health and safety.
m Important!
When using the equipment, a few safety precau-
tions must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual
in a safe place, so that the information is available
at all times.
If you give the equipment to any other person, hand
over these operating instructions and safety regula-
tions as well.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is still
impossible to eliminate certain residual risk factors.
The following hazards may arise in connection with
the machine's construction and design:
• Contact with the saw blade in the uncovered saw
zone.
• Reaching into the running saw blade (cut injuries).
• Kick-back of workpieces and parts of workpieces
• Saw blade fracturing.
• Catapulting of faulty carbide tips from the saw blade.
• Damage to hearing if essential ear-muffs are not
worn.
• Harmful emissions of wood dust when the machine
is used in closed rooms.
m Please note that our equipment has not been de-
signed for use in commercial, trade or industrial ap-
plications. Our warranty will be voided if the machine
is used in commercial, trade or industrial businesses
or for equivalent purposes.
www.scheppach.com