Descargar Imprimir esta página

Makita DFL061F Manual De Instrucciones página 9

Ocultar thumbs Ver también para DFL061F:

Publicidad

Idiomas disponibles

Idiomas disponibles

For tools without retracting sleeve
To install the bit, just insert the bit into the spindle as far
as it will go. To remove the bit, pull the bit out firmly.
OPERATION
Hold the tool firmly and place the socket over the bolt or nut.
Then switch the tool on. When the clutch cuts in, the motor
will stop automatically. Then release the switch trigger.
NOTE:
Hold the tool with its square drive pointed straight at
the bolt or nut, or the bolt or nut will be damaged.
Limits of fastening capacity
Use the tool within the range of the revolution angle up to
360°. If you use the tool beyond the upper limit of this range,
the clutch does not work. And the tool cannot deliver enough
fastening torque (LED flickers in red and green alternatively).
NOTE:
The revolution angle means the angle which
a screw/bolt revolves when the tool attains to
100% from 50% of desired torque.
Use of a low temperature conditioned battery
cartridge may sometimes give warning for
battery cartridge capacity by warning lamp and
beeper which makes the tool stop immediately.
In this case, the fastening capacity may be
inferior to the specification on this manual even
if a charged battery cartridge is used.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Replacing carbon brushes
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► 1. Screwdriver 2. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
NOTE:
MAKITA LIMITED WARRANTY
Please refer to the annexed warranty sheet for the most
current warranty terms applicable to this product.If annexed
warranty sheet is not available, refer to the warranty details
1
set forth at below website for your respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
9 ENGLISH
CAUTION:
These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
Protector
Makita genuine battery and charger
Angle head set
Adjust grip
Anti kickback attachment
Spindle complete
Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
1
2

Publicidad

loading

Este manual también es adecuado para:

Dfl082fDfl084fDfl122fDfl202f