OHAUS T21P Manual De Instrucciones página 11

T21P Indicator EN-9
3.7 Check Weigh Mode
Use this mode to compare samples to a target weight range.
Under = weight is below preset minimum value.
Accept = weight is equal or within preset target range.
Over = weight exceeds preset maximum value.
Refer to Section 4.2 to enable check weigh, to select the alarm and to set limits.
3.8 Changing Units of Measure
Only one unit can be active at any time (kg or lb).
F1-3
To select the active unit enter the User Settings Menu [ ] (Section 4.3).
:
NOTE When selecting 'lb', make sure to apply the supplied 'lb' label over the 'kg'
text on the overlay.