osann Swift360 S Manual Del Usuario página 23

INSTALLATION OF THE CHILD CAR SEAT
1) Height range 76–105 cm, max. 18 kg, rear-facing
1 . Set the child car seat to the maximum reclining position and turn it until it is in rear-facing
seat position R.
2 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
3 . Guide the Isofi x connectors onto the Isofi x anchor points on the vehicle seat and ensure that
they lock into position.
4 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators are showing green.
5 . Take the top tether from its storage pocket and extend it to the maximum length.
6 . The top tether strap must be threaded through the top tether guide on the side of the child
car seat. Ideally, use the guide towards the interior of your car to allow rotation towards the
car door for easy entry and exit.
7 . Clip the top tether onto the hook provided in your car (e.g. on the back of the car seat or in the
boot. Please consult your car manual for this).
8 . Tighten the top tether until the display on the top tether turns green.
9 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
10 . Unfasten the belt buckle on the child car seat and place the belts over the outside of the seat.
11 . Put your child in the child car seat.
12 . Adjust the height of the headrest as described above.
13 . Fasten the belt buckle again until you hear a click.
14 . Pull the front adjustment strap to tighten the belts. Ensure that the straps are not twisted.
15 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
- 23 -
EN