osann Swift360 S Manual Del Usuario página 25

3) Height range 100–150 cm, forward-facing
1 . The 5-point belt on the child car seat must be removed as previously described. The top
tether strap must be released and put back into the storage pocket. These are not needed for
children of this height.
2 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
3 . Guide the Isofi x connectors to the Isofi x anchor points on the car seat and snap them into
place.
4 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators have turned green.
5 . Thread the diagonal belt of the 3-point car seat belt through the diagonal belt guide on the
headrest of the child car seat.
6 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
7 . Put your child in the child car seat.
8 . Adjust the height of the headrest so that the child's head is fully in the headrest and the diagonal
belt comes out through the belt guide at the level of the child's shoulders.
9 . Turn the seat into the forward-facing position. Check that the child car seat is locked in this
position.
10 . Fasten the belt buckle of the 3-point seat belt until you hear a click.
11 . Pull on the diagonal strap to tighten it. Make sure that the straps are not twisted.
12 . The seat position must be set to position 1.
- 25 -
EN