Publicidad
Idiomas disponibles
Idiomas disponibles
Loading
Upper Rack
Glasses, cups, stemware, light-weight plastics, plates,
bowls, pans, long-handled utensils etc. can be loaded
in this rack. Do not load glasses over the tines.
The Stack-Rack
TM
(select models) on the
right side of the upper
rack folds up or down
for loading flexibility.
Fold it down to hold
long-handled knives,
spatulas and spoons or short items like cups or juice
glasses. Fold it up for taller items like glasses, bowls,
plates, etc.
The edge of the
Stack-Rack
(select
TM
models) is designed
to hold stemware in
place. Taller stemware
will fit better on the
right side as the
upper rack is deeper
on this side.
Lower Rack
A variety of items such as dinner plates, mixing bowls,
pots and pans and baking dishes can be loaded in this
rack.
Wider items can be placed along the left side and
back of this rack.
Utensil Basket
Removable Standard Utensil Basket
(style may vary)
For best cleaning results, prevent
items from nesting together by
placing some items in the basket
with handles up and some with
handles down. On slotted covers,
load knives handles up and
spoons and forks handles down.
Be sure that thin, finely pointed items do not extend
through the basket. This could block the lower wash
arm.
Auxiliary Basket
Use this supplemental basket in
the upper or lower rack for
loading miscellaneous items and
utensils. This is also a safe place
to load sharp knives and pointed
items.
Removing the Upper Rack
The rack can be removed when tall or oversized items
need to be loaded into the lower rack. Unload the
rack before removing it from the dishwasher.
To remove rack with tab-lock rack stops:
1. Roll the rack
1
⁄
to
3
2. Locate the rack stops at the end of each track.
Squeeze the tab in the middle of the rack stop and
pull the rack stop straight out. Take care to support
the rack while removing the rack stops.
3. Roll the rack all the
way out of the track
and remove from
the dishwasher.
To replace:
1. Replace the
dishwasher rack by
guiding the wheels
into the tracks.
2. Push each rack stop squarely into the end of the
track until the catch pops into the small hole on the
side of the track.
Important:
The dishwasher will not
operate correctly if the
wash arm is not aligned
with one of the water
inlet holes on back wall
of the dishwasher.
4
(select models)
1
⁄
of the way out.
2
Tab Lock
Style may vary by model
Tab Lock
Rack Stop
Publicidad
