Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
EN
Read this user manual carefully before using the
product. If you do not observe the instructions on
proper handling in this manual, we shall not be held
liable for any resulting personal injury or damage to
property.
1. Please install this product within the voltage
range specified. Failure to do so can cause
electric shock or product malfunction.
2. Electric shocks or product malfunctions may
occur if this product is installed incorrectly.
3. I f s m o ke o r a b u r n i n g s m e l l i s d e t e c t e d ,
disconnect the system immediately.
4. When you install the system, the car should be in
powered off state.
5. Pay attention to the difference on the size of the
hole saw for the sensors. The sensor should not
be installed too tightly or too loose.
6. Do not locate the control unit near to other
interference such as exhaust pipe or other wires.
7. Where the power cable may touch a metal case,
cover the cable with a friction tape. A short circuit
or disconnected wire may cause a fire.
8. Feed as much cable as possible into the vehicle
and clamp it securely. This reduces the possibility
of the cable being hooked or snagged.
9. Keep all cables away from hot or moving parts
and electrical noisy components.
34
Publicidad
