Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO CLEAN CLOTH VACUCIDE BAG ( Model PF1886VC)
Disconnect unit from electrical outlet before cleaning bag
1. Unhook spring from hook
2. Turn knob and release bag support from bag support guide
3. Release bag closing clip from Permanent Bag. Still holding the bag. put the opening in a plastic bag and shake well to
empty it
4. Insert bag closing clip to Permanent Bag
5. Hold Permanent Bag on back of unit with printing facing handle tube. Slide lower bag support into slots of bag support
guide. Push bag support towards inlet and turn knob to fasten Insert spring onto hook
CAUTION: Be sure to clean fan chamber every time you empty permanent bag.
NOTE:
Turn off the switch and unplug the electrical cord before replacing belt
Belt can become hot during normal use To prevent injury, avoid touching the belt
and motor nut when it is hot.
CAUTION: Improper installation of the brush roll or
brush roll belt could cause carpet cleaner
damage .
1. Push handle release and lower handle; push the height
setting to the lowest position Turn the vacuum cleaner
so the underneath side and brush roll face toward you
(Fig 6)
2. Remove retainer bar by pushing downward on the right
end, until it unhooks. Release other end
CAUTION: While pushing one end of retainer bar,
hold the machine down to avoid tilting.
3. Remove bottom plate and fan cover by lifting off from
motor ( Fig 7
4. Remove belt from motor nut. Pull brush roll up, remove
belt from brush roll and change with a new belt
5. Insert brush roll making sure the tabs on the edge of
bearing support are facing upward. Bristles on brush
roll must form a "V" 1 facing toward you
6. Twist the belt towards the right and place around motor
nut. The higher end of the belt must be on the right
side and the lower end on the left side, as shown in the
drawing below ( Fig 8 ) Rotate brush to ensure belt is
positioned correctly
All manuals and user guides at all-guides.com
HOW TO REPLACE BRUSH ROLL BELT
– 7 –
Publicidad
