Chicco Cuddle&Bubble comfort Manual página 13

to prevent access of the child to
hot water supply.
• Before bathing the baby, check
that the water temperature is cor-
rect with a thermometer.
• Always check the stability of the
product before use. Always place
the product on a at surface that
is su cient to support it.
• Always make sure that the prod-
uct is resting on a at, dry and sta-
ble surface.
• Do not use the product if any
component is broken or missing.
• Do not use replacement parts or
accessories other than those ap-
proved by the manufacturer.
• This bath tub can be used alone
or on the changing unit frame up
to when the child tries to stand up
by itself.
• Always check the attachment and
stability of the bath tub on chang-
ing unit frame.
• Mix the water to avoid hotter or
cold areas.
• Only an adult may wash the baby.
• Never turn the child on its stom-
ach inside the tub.
• Before lling the tub with water,
make sure that the plug is seated
properly.
• Fill the tub up to the MAX level in-
dicated by the line. It is dangerous
to exceed the maximum lling
level of the tub.
• Do not leave objects in the tub
when bathing.
• When using the tub make sure
that the plug has been tted cor-
rectly.
• Before placing the child in the wa-
ter for the bath, make sure that
the changing table is always se-
cured in place from the side of the
frame.
• The use of the tub is allowed with
only one child at a time.
• Do not have any electrical appli-
ances or electrical cables near the
product.
• When not in use, keep the prod-
uct away from children.
USING THE WASH TUB
The tub B supplied can be used as follows:
• Installed on the frame A ( g. 17).
• To access the tub B turn the changing table A2
over on its back side ( g. 18).
• Before use, fasten the safety strap A8 to the fa-
stening block A6 ( g. 28A).
• Before lling the tub B, make sure that the plug
B1 is correctly closed ( g. 20).
• On a at surface or inside an adult bath tub ( g. 19).
• Before lling the tub B, make sure that the plug
B1 is correctly closed ( g. 20), making sure to re-
move drain plug and hose B2 by unscrewing it
to ensure product stability ( g. 21).
• Then proceed with lling of the tub B to the
maximum level indicated by the appropriate
symbol on the inner surface of the tub B ( g. 22).
• The hand shower for adults can be temporarily
positioned in the dedicated grip on the short
side of the tub B ( g. 23).
WARNING: Perform this operation before put-
ting the baby inside the tub.
• To empty the tank B, if installed on the frame, it
is advisable to use the special tube B2 ( g 25),
after opening the rubber plug B1 ( g. 24).
• Alternatively, if the tank B is used in a bath tub or
other at surface, empty it by opening the cap
(Fig. 24) or turning it over to drain the water.
WARNING: Drain water into a drain (e.g. bath,
toilet, washbasin, bidet).
WARNING: Drain the tub only after the baby
has been removed.
• When it is not being used, the tube B2 must be
hooked to the relevant fastening point ( g. 29).
• The structure is provided with a towel holder
( g. 36A-36B).
CLOSING THE PRODUCT
To close the product:
1. Release both buttons from the xing blocks
13