Jata electro PL520 Instrucciones De Uso página 11

the manufacturing process of the appliance may contaminate
the steam. We recommend that you allow the steam to flow
for a few minutes before starting to iron.
• It there still rests of water in the tank, it is due to the quality
controls made in our production line.
• The cleaning and maintenance done by users, can not be
done by children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTIONS OF USE
ATTENTION: Before plugging the steam iron to the mains, be sure the steam switch (2) IS
NOT PUSHED. If when connecting the steam iron the pump starts working press immediately
the steam pusher (2) to avoid leakage from the sole plate or to avoid the pump is damaged
in case of not water in the water tank.
STEAM IRONING
• Set the temperature selector (6) to its maximum position (max) by turning it clockwise.
• To fill the tank, always do so with the iron unplugged from the mains.
• Open the filling lid (4) and pour water into the tank using the cup provided.
• Do not go over the MAX. indication of the tank (7) to avoid overflowing.
• Replace the lid.
• Plug the iron into the mains. The indicator (1) will light on.
• Once the pilot light (1) goes off, the steam iron is ready for ironing.
• Push the steam switch (2) to get steam. Push again this switch to stop the steam.
• During the steam ironing keep always the water tank with water. If there is not water in the tank
you will listen the pump noise and the steam will stop. Push the steam switch (2) and switch off
the appliance to refill again the water tank.
SPRAY IRONING
• To obtain a spray, the temperature selector (6) position is unimportant.
• Press the spray button (3). In case no water should come out, press the button again.
DRY IRONING
• If there is water in the tank, do not press the steam switch.
• Plug the iron into the mains and place the selector (6) in the desired temperature for each fabric:
FIBRAS SINTÉTICAS : SINTHETIC FIBRES: Low temperature (•)
SEDA – LANA : SILK – WOOL: Medium temperature (••)
ALGODÓN – LINO : COTTON – LINEN: High temperature (•••-MAX)
11