Sauder Clifford Place Serie Instrucciones De Montaje página 25

Step 21
å
Fasten the HINGES (12) to the DOOR (V). Use four SILVER 1/2" FLAT HEAD SCREWS (24).
å
Fasten the PULL (8) to the DOOR (V). Use two BLACK 1/2" FLAT HEAD SCREWS (26).
å
Fasten the HINGES on the DOOR (V) to the HINGE BRACKETS on the RIGHT END (A).
å
Follow the large diagram below fastening both HINGES to the HINGE BRACKETS keeping the DOOR vertical at all times.
å
Tighten the mounting screws in the HINGE BRACKETS.
12
429508
8
BLACK 1/2" FLAT HEAD SCREW
(2 used for PULL)
V
www.sauder.com/service
26
Mounting screw
A
C
This screw will fit
into this slot. Then
tighten the screw.
24
SILVER 1/2" FLAT HEAD SCREW
(4 used for the HINGES)
V
The screw on the back
side of the HINGE will
fit into this slot.
Page 25