Sauder Clifford Place Serie Instrucciones De Montaje página 28

Step 24
å
Push the RUBBER SLEEVES (16) over the METAL PINS (15). Insert the METAL PINS into the hole locations of your
choice in the RIGHT END (A) and UPRIGHT (C). Set the ADJUSTABLE SHELF (H) onto the METAL PINS.
å
To insert a drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the
unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way
in, then it will slide in and out easier.
å
Peel an applique from the SMALL APPLIQUE CARD (13) and stick them on the visible HIDDEN CAMS.
å
NOTE: To raise a corner of the unit, turn the ADJUSTABLE GLIDE counter-clockwise. To lower a corner, turn the
ADJUSTABLE GLIDE clockwise.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
NOTE: Make any needed adjustments to the
ADJUSTABLE GLIDES to level your unit.
Page 28
50 lbs.
30 lbs.
35 lbs.
www.sauder.com/service
A
20 lbs.
H
25 lbs.
13
To cover visible
HIDDEN CAMS
15
16
429508