Sauder Clifford Place Serie Instrucciones De Montaje página 7

Step 3
å
Separate the EXTENSION SLIDES (Y) from the
EXTENSION RAILS (X) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (X) to the LEFT END (B) and
UPRIGHT (C). Use six BLACK 1/2" PAN HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into
the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the
other holes that lines up with the holes in the ENDS. Turn
a SCREW into those holes.
å
NOTE: The EXTENSION SLIDES (Y) will be used later for
the DRAWERS.
Use these holes.
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
Open end
429508
X
Pull down on the black release lever and pull the SLIDE from the RAIL.
X
23
X
C
www.sauder.com/service
Y
Y
Open end
X
B
7
Page 7