Step 7
Step
å
Separate the WIDE EXTENSION SLIDES (32) from the WIDE EXTENSION RAILS (31) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (31) to the UPRIGHTS (C and D). Use eight BLACK 5/8" FLAT HEAD SCREWS (22).
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the SLIDING SHELF.
å
Fasten two EXTENSION RAILS (1) to the UPRIGHTS (C and D). Use six BLACK 5/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
å
Insert a GROMMET (13) into the large hole in the UPRIGHTS (C and D) as shown.
32
Push the release lever in and pull the SLIDE from the RAIL.
13
Closed end
Open end
Page 12
Closed end
31
1
C
Use these holes.
www.sauder.com
31
13
31
D
1
1
hole
st
7
Closed end
BLACK 5/8" FLAT HEAD SCREW
(14 used in this step)
1
Open end
Closed end
22
428247