Sauder Clifford Place Serie Instrucciones De Montaje página 10

Step 6
å
Carefully turn the Hutch over onto its back.
å
If you are fastening the Hutch to the 433359 Lateral File, you will need to complete Steps 1-18 in the 433359
book before fastening the Hutch to the Lateral File Top.
å
If you are fastening the Hutch to the 433360 Library Base, you will need to complete Steps 1-10 in the
433360 book before fastening the Hutch to the Library Base Top.
å
The following steps show the Hutch being fastened to the Library Base.
å
Finish drilling the two holes shown in the bottom surface of the Library Base Top using a 1/4" drill bit. Follow
the diagram.
å
Next, fasten the Library Base Top to the ENDS (A and B). Use two 1-1/2" FLAT HEAD SCREWS (10).
o p
e T
B a s
r a r y
L i b
The large hole is
closer to this edge.
Page 10
Finish drilling these two
holes from the bottom
surface. Use a 1/4" drill bit.
A
B
www.sauder.com/service
o p
e T
B a s
r a r y
L i b
10
1-1/2" FLAT HEAD SCREW
(2 used in this step)
433363