Sauder Clifford Place Serie Instrucciones De Montaje página 9

Step 5
å
Carefully turn your unit over onto its front edges.
å
Fasten the ENDS (A and B) to the BRACE (D). Use two
1-1/2" FLAT HEAD SCREWS (10).
å
Insert six BACK CONNECTORS (7) into the grooves in the
ENDS (A and B). Space the BACK CONNECTORS as shown in
the diagram.
å
NOTE: You may need to gently tap them in with your hammer.
å
Fasten the BACK (K) to your unit. Use six 5/8" FLAT HEAD
SCREWS (13) through the BACK CONNECTORS and into
the ENDS.
5/8" FLAT HEAD SCREW
(6 used in this step)
7
1-1/2" FLAT HEAD SCREW
(2 used in this step)
433363
13
A
10
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
K
D
7
B
Page 9