Sauder Clifford Place Serie Instrucciones De Montaje página 13

Step 9
å
Place your unit in its final location.
å
NOTE: The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a
wall stud, go to the next step now.
å
1 - Locate the center of a stud in your wall near your unit and mark it with a pencil.
st
å
2 - Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3 - Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
rd
å
Push the RUBBER SLEEVES (6) over the METAL PINS (5). Insert the METAL PINS into the hole locations of your choice
in the ENDS (A and B). Set the ADJUSTABLE SHELVES (F and G) onto the METAL PINS.
å
Peel the STICKERS from the APPLIQUE CARD (8) and stick one onto each visible HIDDEN CAM and SCREW.
Mark and drill
a 1/8" hole into
the wall stud.
1
st
96
To cover visible
HIDDEN CAMS
and SCREWS
433363
Electric drill with 1/8" bit
2
nd
3
rd
8
www.sauder.com/service
(8 used)
6
J
B
F
G
5
A
Page 13