Sauder Clifford Place Serie Instrucciones De Montaje página 14

Step 10
å
1 - With your pencil, strike a mark through the center of the hole in the SAFETY STRAP.
st
å
2 - Drill a 3/8" hole on the mark.
nd
å
3 - While you squeeze the wings together, gently tap the WALL ANCHOR from the FURNITURE TIPPING RESTRAINT
rd
KIT (96) into the hole until it is even with the surface of the wall.
å
4 - Turn the LONG SCREW through the hole in the SAFETY STRAP and into the WALL ANCHOR.
th
å
NOTE: You will need to turn the LONG SCREW multiple turns to completely tighten and secure your unit to the wall.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
Mark and drill
a 3/8" hole
into the wall.
3
rd
4
th
1
st
96
Page 14
Electric drill with 3/8" bit
2
nd
www.sauder.com/service
No load
25 lbs.
25 lbs.
433363