Sauder Rollingwood Serie Instrucciones De Montaje página 10

Step 4
å
Separate two SHORT EXTENSION SLIDES (2) from two SHORT EXTENSION RAILS (1) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the SHORT EXTENSION RAILS (1) to the LEFT END (C). Use six 1/2" PAN HEAD SCREWS (33).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
Open end
Page 10
1/2" PAN HEAD SCREW
(6 used in this step)
1
1
www.sauder.com/service
Use these holes.
33
C
7
1
These CAM SCREWS
must be here.
431433