Descargar Imprimir esta página

Sauder Rollingwood Serie Instrucciones De Montaje página 16

Ocultar thumbs Ver también para Rollingwood Serie:

Publicidad

Step 10
å
Separate two SHORT EXTENSION SLIDES (2) from two SHORT EXTENSION RAILS (1) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the SHORT EXTENSION RAILS (1) to the LEFT UPRIGHT (D). Use six 1/2" PAN HEAD SCREWS (33).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the UPRIGHT. Turn a SCREW
into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Page 16
33
1/2" PAN HEAD SCREW
(6 used in this step)
1
www.sauder.com/service
1
Use these holes.
Open end
1
D
7
Open end
431433

Publicidad

loading

Este manual también es adecuado para:

Rollingwood 431433