Sauder Rollingwood Serie Instrucciones De Montaje página 11

Step 5
å
Separate a LONG EXTENSION SLIDE (4) from a LONG EXTENSION RAIL (3) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten the LONG EXTENSION RAIL (3) to the LEFT END (C). Use three 1/2" PAN HEAD SCREWS (33).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
4
Push the black lever and pull the SLIDE from the RAIL.
Open end
431433
33
1/2" PAN HEAD SCREW
(3 used in this step)
3
C
www.sauder.com/service
7
3
Use these holes.
Page 11