Sauder Rollingwood Serie Instrucciones De Montaje página 17

Step 11
å
Separate a LONG EXTENSION SLIDE (4) from a LONG EXTENSION RAIL (3) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten the LONG EXTENSION RAIL (3) to the LEFT UPRIGHT (D). Use three 1/2" PAN HEAD SCREWS (33).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the UPRIGHT. Turn a SCREW
into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
4
Push the black lever and pull the SLIDE from the RAIL.
431433
D
1/2" PAN HEAD SCREW
(3 used in this step)
www.sauder.com/service
3
33
7
3
Use these holes.
Open end
Page 17