Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 14

Step 8
å
First, fasten the INNER SKIRT (FF) to the CENTER SKIRT (S). Use
three SILVER 1-5/8" FLAT HEAD SCREWS (152S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Next, fill the holes in the OUTER SKIRT (R) 1/4 to 1/2 full with
GLUE (177M). Then, insert the WOOD DOWELS (15F) into the
holes. Wipe away the excess GLUE.
å
Now, fill the holes in the END SUPPORT BOTTOM MOLDING (EE)
1/4 to 1/2 full with GLUE. Then, insert the WOOD DOWELS in the
OUTER SKIRT (R) into these holes. Wipe away the excess GLUE.
These surfaces
should be even.
Page 14
15F
R
EE
427803
e
f a c
s u r
e d
n i s h
U n fi
S
FF
177M
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely difficult.
152S
SILVER 1-5/8" FLAT HEAD SCREW
(3 used in this step)
www.sauder.com/commercial-office/service