Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 18

Step 12
å
Fasten the LONG TOP BRACES (Q) to the LONG TOP (G). Use eight SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
NOTE: The angled edge of the BRACE should face down and toward the back edge of the TOP.
å
Fasten the END SUPPORT TOP MOLDING (N) to the LONG TOP (G). Use three SILVER 1-5/8" FLAT HEAD SCREWS (152S).
152S
SILVER 1-5/8" FLAT HEAD SCREW
(3 used in this step)
Page 18
N
G
427803
10S
SILVER 1-1/8" FLAT HEAD SCREW
(8 used in this step)
Q
Back edge
www.sauder.com/commercial-office/service
Angled edge
Q