Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 30

Step 24
å
Fasten the TOP MOLDING (W) to the SHORT TOP (H). Use two SILVER 1-5/8" FLAT HEAD SCREWS (152S).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Turn the two LOCK MECHANISMS inside the RIGHT PEDESTAL exactly as shown until they stop moving.
å
Turn the LOCK MECHANISM behind the TOP MOLDING (W) toward the RIGHT PEDESTAL until it stops moving.
152S
SILVER 1-5/8" FLAT HEAD SCREW
(2 used in this step)
Page 30
This edge will be snug
against the LEFT PANEL
on the RIGHT PEDESTAL
when locked in place.
427803
This LOCK MECHANISM will face
toward the RIGHT PEDESTAL
when locked in place.
W
This edge will be snug
against the front BRACE
on the RIGHT PEDESTAL
when locked in place.
www.sauder.com/commercial-office/service
The angled edge
should be toward the
inside of your unit.
H
RIGHT PEDESTAL