Publicidad
Idiomas disponibles
Idiomas disponibles
13. Complete the Installation
NOTE: For DTV+ Installations: Before operating the system for the first time, download and install the latest software for
connected components. This may take an hour or more to complete based on system configuration and internet
connection speed. Do not disconnect the power from any components during software download and installation.
IMPORTANT! If installing the Perfect Fill with an existing DTV+, download and install the latest firmware for the DTV+.
Install the trim following the instructions that came with the trim.
Turn ON the water supplies and check for leaks.
Press the ON/OFF Switch to close the drain and start the water flow. Allow the bath to fill with water and check for
leaks. Press the ON/OFF Switch again to stop the water flow. Press the ON/OFF Switch a third time to open the drain
and empty the bath.
To complete the bath installation, refer to the Quick Reference Guide to setup and test the bath.
For information on operating the Perfect Fill using the DTV+ system, refer to the guide on the K-99695 controller
product page at kohler.com.
Leave the Quick Reference Guide with the homeowner.
Kohler Co.
21
1504928-2-A
Publicidad
